IFD Interface to Sandia SAE 5-35
The Following Interface Information is "FOR REFERENCE USE ONLY" and is not FAA Approved Data. Please see the applicable STC Installation manuals, or other Approved documentation for installation approval. IFD Interface to Sandia SAE 5-35
How much does the IFD5xx/4xx Tray Weigh?
IFD5xx 700-00188-000 TRAY AND RF CONNECTOR WEIGHT: 1.16 ± 0.1 LBS (Fixed Wing) 700-00188-001 TRAY AND RF CONNECTOR WEIGHT: 2.25 ± 0.1 LBS (Helicopter) IFD4xx 700-00184-000 TRAY AND RF CONNECTOR WEIGHT: 0.83 ± 0.05 LBS (Fixed Wing) 700-00184-001 TRAY AND RF CONNECTOR WEIGHT: 1.53 ± 0.05 LBS (Helicopter)
IFD Interface with GTX327 (Not Qualified for ADS-B out)
The Following Interface Information is "FOR REFERENCE USE ONLY" and is not FAA Approved Data. Please see the applicable STC Installation manuals, or other Approved documentation for installation approval. IFD Interface with GTX327
IFD4XX/5XX Demo Mode When Installed in an Aircraft
You're using demo endpoint of Iframely API commercially. Max-width is limited to 320px. Please get your own API key at Please read the attached Service Information Letter 606-00182-026 and be advised that before putting an IFD4XX or IFD5XX in demo mode when the IFD is installed in an aircraft that you turn off the AD…
IFD4XX/5XX Demo Mode When Installed in an Aircraft
You're using demo endpoint of Iframely API commercially. Max-width is limited to 320px. Please get your own API key at Please read the attached Service Information Letter 606-00182-026 and be advised that before putting an IFD4XX or IFD5XX in demo mode when the IFD is installed in an aircraft that you must turn off t…
Installing IFD options problem - Load says "IFD appears to not be installed in aircraft Nxxxxx"
Installing IFD options problem - Load says "IFD appears to not be installed in aircraft Nxxxxx" In this scenario, the IFD is reporting that the aircraft tail number used to create the options/dsf file does not match the current IFD configuration on "Main System Config Page 3" as shown below: The aircraft ta…
IFD interface to Shadin DigiFlo-L
The Following Interface Information is "FOR REFERENCE USE ONLY" and is not FAA Approved Data. Please see the applicable STC Installation manuals, or other Approved documentation for installation approval. IFD interface to Shadin DigiFlo-L
How to Calibrate an analog OBS input to the IFD
The following does not apply to the KI208A or KI209A indicators. If you get continual messages on the IFD to "Set Course To xxx" and your analog CRS is set correctly, it likely means you need to calibrate your OBS input. You will need to boot the IFD into Mx mode, and toggle to the "Config" tab. From here you wi…
