Entegra EXP5000 PFD with DFC90 message bar dashed out
When installing the DFC90 into an approved aircraft, if you see the Entegra PFD Autopilot Message bar dashed out (see photo), you need to check the configuration of the AutoPilot in the PFD Maintenance Mode pages. Ensure the PFD has MOD55 (mandatory requirement for the DFC90), otherwise the DFC90 cannot communicate …
DFC Disconnects
Thank you for your reply and additional information. The most common cause of erratic DFC operation is the Start Voltages of the Roll and Pitch Trim Motors. A good Motor will begin to respond at around 2 Volts. Any voltage beyond 2.5 volts will cause erratic operation of the autopilot. The autopilot is also …
IFD Interfaces with Analog Autopilots
IFD Analog Autopilot Interfaces IFD GPSS Interfaces
Entegra EXP5000 PFD AutoPilot configuration Cirrus
This is informational use only, all inquiries regarding the Auto Pilot issue below must be referred to Cirrus. Issue: shop is able to save Auto Pilot as "Not Installed". Workaround: None, this is required by Cirrus NOTES: Cirrus requires the PFD validate the configuration options, and only allow the options tha…
DFC90 upgrade in Cirrus S-Tec 55X Autopilot installed aircraft
(Informational only - shops must check the aircraft and equipment for confirmation) Do you have a Cirrus Entegra Equipped EX5000 (PFD and MFD) Series and an installed S-TEC55X; and want to upgrade to the DFC90? The DFC90 utilizes the existing Roll Trim Motor, Pitch Servo, and Pitch Trim motors that are presently …
